PC Configurations Windows 95 Help Windows 98 Help Windows NT Help Windows Millennium Edition Help Windows XP Home Edition Help Dial-up Error Codes Modem Troubleshooting

Email Configurations Configure MS Outlook Express Mail Configure MS Internet Mail Configure Microsoft Outlook Configure Eudora Mail F.A.Q. Techinical Support Home

Dial-up set up for Windows NT

Installing Dial-Up Networking (DUN) and Remote Access Service (RAS)

To install DUN and RAS on your Windows NT 4.0-based computer, follow these steps:

1. Click Start, point to Programs, point to Accessories, and then click Dial-Up Networking.
   
   
2. Click Install. When you are prompted, type the location of the Windows NT 4.0 installation files.
   
   NOTE: If you are not prompted to install Dial-Up Networking, DUN and RAS have already been installed. Skip to the "Configuring Dial-Up Networking" section in this article.
   
   
3. If you have not installed a RAS-capable device, the Remote Access Setup program prompts you to invoke the Modem installer. Click Yes and follow the instructions to install a modem.
   
   
4. In the list of RAS-capable devices, click the modem you just installed, and then click OK.
   
   
5. Click Configure, click Dial Out Only, and then click OK.
   
   
6. Click Network, click the check boxes of the protocols to use for your connection to select them, and then click OK.
   
   NOTE: The protocols that are currently installed are selected by default. If you choose a protocol that is not currently installed, you must install that protocol using the Network tool in Control Panel.
   
   
7. Click Continue, and then click Restart to restart your computer and finish the installation.
   
   

Configuring Dial-Up Networking (DUN)

To configure DUN to make a connection to a Windows NT or third-party RAS server, follow these steps:

1. Click Start, point to Programs, point to Accessories, and then click Dial-Up Networking.
   
   
2. By default, there are no entries in the phone book. Click OK to add a new entry. If you are reinstalling DUN, there may be existing phone book entries. To create a new entry, click New.
   
   
3. Type a name for the phone book entry to identify your connection, and then click Next.
   
   
4. Click any of the check boxes that apply for this connection to select them, and then click Next. If you are unsure whether any of these check boxes apply, see the RAS server administrator.
   
   
5. Type the phone number for the RAS server, click Next, and then click Finish.
   
   
6. Click Dial to connect.
   
   

Below is graphical help of dial-up set up:

Click Start, point to Programs, point to Accessories, and then click Dial-Up Networking. A window like the one below will appear. Type in "MegaByte OnLine" for the "Name the new phonebook entry". Then Click "Next".

When you see the a window like the one below, enter the dial-up access number:

Dial-up access number:  2361700

If you are having problem setting up dial-up properties in your computer, please call our tech support line at 541-673-2428.